VR2 CONTROL SYSTEM
SK77898/2
PG DRIVES TECHNOLOGY
18
condition could result in a burns hazard or fire hazard.
PGDT accepts no liability for losses of any kind arising
from failure to comply with this condition.
Only use the battery charger that has been supplied with
your wheelchair. The use of incorrect chargers could damage
the batteries, wheelchair, control system or charger itself,
or may result in parts overheating creating the potential
for burns or even fire. PGDT accepts no liability for losses
of any kind if the charger is incompatible with the control
system (see Chapter 2, sections 7.1 and 7.2) or any other
part of the wheelchair system.
11 Programming
If you cannot find a maximum speed control setting that suits you, the control system
can be programmed to meet your needs. Programming can be performed using a
PP1a Programmer or specialist PC software and interface cable.
The PP1a is a small hand-held unit which can be plugged into your control system to
alter the program. Your wheelchair distributor or service agent or wheelchair
manufacturer will be able to program your control system for you.
If you have a PP1a, read the PP1a user guide before you use it.
If you re-program your control system, make sure that you observe any restrictions
given in your wheelchair user manual. Note any changes you make for future
reference.
Programming should only be conducted by healthcare
professionals with in-depth knowledge of PGDT electronic
control systems. Incorrect programming could result in an
unsafe set-up of a wheelchair for a user. PGDT accepts no
liability for losses of any kind if the programming of the
control system is altered from factory pre-set values.
To Next Page
Loading...
Need help?
General