VR2 CONTROL SYSTEM
SK77898/2
PG DRIVES TECHNOLOGY
134
2.25 Mounting
It is possible for the case temperature of the Lighting Module
to rise above 41°C (107°F). For this reason the Lighting Module
should be fixed in a position where it cannot be touched by
the wheelchair user. Chapter 4 section 3.1.
2.26 Wiring
For lighting module sockets 1 and 2 only use the exact
parts specified below for the mating connector.
PGDT accepts no liability for losses of any kind arising
from damage to or failure of the wheelchair lighting system,
including any associated wiring. It is the responsibility of
the wheelchair manufacturer to ensure that the lighting
system wiring complies with all relevant standards. Chapter
4 section 3.4.
2.27 Lamp Wattage
24V/5W lamps can not be used. PGDT accepts no liability
for losses of any kind arising from damage to or failure of
the wheelchair lighting system. Chapter 4 section 4.2.
2.28 Servicing - Introduction
Any replacement work carried out without the wheelchair
manufacturers permission will invalidate the control systems
warranty. PGDT accepts no liability for losses of any kind
if the procedure and safety guidelines are not followed. These
operations should only be carried out by a trained Healthcare
Technician. Chapter 6 section 1.1.
2.29 Diagnostics - Introduction
Diagnostics should only be conducted by healthcare
professionals with in-depth knowledge of PGDT electronic
controllers. An incorrect or badly effected repair could result
in an unsafe set-up of a wheelchair. PGDT accept no liability
for losses of any kind arising from an incorrect or badly
effected repair. Chapter 6 section 2.1.
To Next Page
Loading...
Need help?
General