PG DRIVES TECHNOLOGY
7
CHAPTER 1 - OPERATION
SK77898/2
This is an indicator that shows the selected drive profile. There may be up to 5 drive
profiles available, this depends on the programming of the control system (refer to
Chapter 3). For details of how to select drive profiles, see sections 3.6 and 3.7.
3.5 Horn Button
The horn will sound while this button is depressed.
3.6 Speed / Profile Decrease Button
This button decreases the maximum speed setting or, if the control system is
programmed for drive profile operation, selects a lower drive profile.
It is possible to program the control system so this button has no effect while the
wheelchair is being driven, refer to Chapter 3.
3.7 Speed / Profile Increase Button
This button increases the maximum speed setting or, if the control system is
programmed for drive profile operation, selects a higher drive profile.
It is possible to program the control system so this button has no effect while the
wheelchair is being driven, refer to Chapter 3.
3.8 Actuator Buttons and LEDs
Depending on whether the wheelchair is fitted with one or two actuators, the operation
of these buttons will differ. Refer to the relevant section below.
3.8.1 Wheelchairs with One Actuator
Depressing either actuator button will enter actuator adjustment mode. This will be
indicated by the illumination of both actuator LEDs. Actuator adjustment can then
be made by deflecting the joystick. To re-enter drive mode, depress either actuator
button.
3.8.2 Wheelchairs with Two Actuators
Depressing either actuator button will enter actuator adjustment mode. If the left
button was depressed the associated LED will be illuminated, and deflection of the
joystick will adjust the actuator motor connected to that channel. If the right button
was depressed the associated LED will be illuminated and deflection of the joystick
will adjust the actuator connected to the other channel.
To re-enter drive mode depress the selected actuator button, as indicated by the
associated LED.
To select the other actuator, depress the opposite actuator button. It is also possible
to select the other actuator by left or right movements of the joystick. This alternative
To Next Page
Loading...
Need help?
General