VR2 CONTROL SYSTEM
SK77898/2
PG DRIVES TECHNOLOGY
8
selection method is dependent on the programming of the control system, see
Chapter 3.
3.9 Charger and Programmer Socket
This socket should only be used for programming and charging the wheelchair.
Refer to section 10 for more details.
This socket should not be used as a power supply for any other electrical device.
Connection of other electrical devices may damage the control system or affect
the E.M.C. performance of the wheelchair.
The control systems warranty will be voided if any device
other than a PG Drives Technology Programmer, or the
battery charger supplied with the wheelchair, is connected
into this socket.
VR2 JOYSTICK ACTUATOR ADJUSTMENT
UP
DOWN
SELECTSELECT
To Next Page
Loading...