VR2 CONTROL SYSTEM
SK77898/2
PG DRIVES TECHNOLOGY
128
If the control system is damaged in any way, or if internal
damage may have occurred through impact or dropping,
have the product checked by qualified personnel before
operating. PGDT accepts no liability for losses of any kind
arising from failure to comply with this condition. Chapter 1
section 13.
2.8 Warranty
The warranty will be void if the VR2 has not been used in
accordance with VR2 Technical Manual SK77898, the VR2
has been subject to misuse or abuse, or if the VR2 has
been modified or repaired by unauthorized persons. Chapter
1 section 14.
2.9 Program Settings
It is the manufacturers responsibility to program the control
system to suit the vehicle model and ensure safe operation
in compliance with relevant legal requirements over the whole
of the operating range. PGDT accepts no liability for losses
of any kind due to failure to, or incorrect programming or
the VR2 Control System. Refer to Chapter 3 for programming
details.
Programming should only be conducted by healthcare
professionals with in-depth knowledge of PGDT electronic
control systems. Incorrect programming could result in an
unsafe set-up of a wheelchair for the user. PGDT accept no
liability for losses of any kind if the programming of the
control system is altered from factory pre-set values. PGDT
accept no liability for losses of any kind if the drive or
stability characteristics of the chair are altered without
prior notification and discussion with PGDT. Chapter 2
section 1.2.
2.10 Charger Interlock
The chair manufacturer is responsible for providing a means
of preventing the use of the wheelchair while the batteries
are being charged. PGDT accepts no liability for losses of
any kind arising from failure to comply with this condition.
Chapter 2 section 2.2.
To Next Page
Loading...