VR2 CONTROL SYSTEM
SK77898/2
PG DRIVES TECHNOLOGY
56
3.7 Actuator End Stop Detection
This can protect the actuator motor from high levels of current over extended periods
of time.
This parameter can be set to On or Off.
On The parameters Actuator End Force and Actuator Current Limit Time
Out are activated and stop the actuator motors.
Off The actuator will not be automatically stopped by the control system.
3.8 Actuator End Stop Bleep
This allows the use of an Audible bleep to tell you when the Actuator is stalled at its
end stop.
This parameter can be set to On or Off.
To Next Page
Loading...
Need help?
General