To Next Page

To Previous Page

113

9.14 Custom Function

The custom functions can store separate three dierent camera set-ups.

When at C-00, chose 1 (A), 2 (B), or 3 (C) to store a specic set of user function

selections for the group of custom settings from C-01 to C-19.

The C-00 is set to 0 which is the settings used for the default set.

Setting Custom Functions

1. Turn on the power.

Turn the shutter release mode lever to the S or C position.

2. Turn the exposure mode dial to select CF (Custom Function mode).

3. Turn the rear dial to select the settings for user A, B, or C.

4. Turn the front dial to select the item you want to set.

Clear all Custom Functions

Set mode dial button to CF, then press +/- button for 5 seconds, this will

reset ALL Custom Functions to the factory default.

Setting Custom Functions to Default

1. By turning the exposure mode dial, CF (custom function mode) can be

selected.

2. By turning the rear dial, user A, B or C can be selected.

3. Press and hold down set button (for longer than 1 second) and settings

for A,B,C can be initialized, or the settings can be returned to “default”.

PhaseOne IQ Series User Manual

Questions and Answers: