PhaseOne IQ Series - Quick Start Guide (Untethered Shooting)

50
1.
2.
2.
3.
4.
4.1 Quick Start (shooting untethered)
1. Connect an IQ2 digital back to the camera and install the focusing screen
if applicable.
2. Charge the batteries (See page 16) then insert them into the camera.
3. Insert a CompactFlash card into the IQ2 Back.
4. Switch on the power to the back and camera and select a drive mode.
5. Choose an exposure mode.
6. Select a focus mode on the camera body and lens if applicable.
7. Set the date and time. (See page 25).
8. Set the ISO and White Balance. (See page 28).
9. After shooting, transfer images into Capture One software from the CF
card using a card reader.
10. Editing images in Capture One and output as required.
5.
6.
4.