46
3.11 Flash Compensation Settings
By combining a Metz ash and the SCA3952 adapter, the camera adjusts for
ash. It can be adjusted within ±3EV in increments of 1/3 steps.
1. Turn on the Power
Install the SCA3952 adapter on the Metz ash, and attach it to the camera.
Lock the ash in place using the locking knob on the ash shoe. Turn the
shutter release mode selector lever to the S or C position, and turn ON the
ash power switch.
2. When the ash charge conrmation lamp lights, press the set button [A] .
The icon is displayed on the main LCD panel.
3. Turn the front or rear dial to select the ash compensation value.
External LCD Panel (normal display)
4. When the shutter button is half-pressed, the display appears on the
external LCD, and appears on the LCD inside the viewnder with a +
compensation, or appears with a – compensation.
Viewnder LCD Readouts
- If the ash-charge mark is not displayed, the ash compensation button [A]
cannot be used.
- Keep pressing the set button to activate the ash compensation mode. You
can check the exposure compensation value.
- If you turn the shutter release mode selector lever to the L (power OFF)
position, the compensation value will be cancelled.
P
Av
Tv
M
X
CF
C1
C2
C3
A
P
Av
Tv
M
X
CF
C1
C2
C3
To Next Page
Loading...
Need help?
General
