149
Flash Lead Connection
A ash cable is always connected to the Hasselblad H1/H2 camera body.
The ash sync cable must not be connected to the camera back when used on
a Hasselblad H1/H2. The ash sync connector on the IQ back is only intended
for use with a Phase One FlexAdaptor or other large format adaptors.
16.4 Cables Shipped with IQ back for Hasselblad H
No cables are required to use the IQ back with a Hasselblad H1/H2.
A Value Added IQ back comes with an additional multi-connector to Lens
sync cable (part# 50300143) for use with large format cameras in two shot
mode.
Part# 50300144 This cable is available as a separate purchase only.
From multi-connector to mini jack female (for use to adapt older Large
format wake-up cables or older Kapture Group one shot adaptor cables to
connect to the multiport).
To Next Page
Loading...
