85
Setting up your IQ2 to connect via Router
1. Turn on WiFi: Menu>WiFi>Mode>On
2. Select network: Menu>WiFi>Select Network
3. Type user name and password as prompted from the network.
Connecting Capture Pilot to your IQ2 when using router:
1. From General>WiFi: Select same network as selected on IQ2
2. Open Capture Pilot.
3. Select “PhaseOne[seial number]” under Local Servers in Capture Pilot
To reset all WiFi settings, including all network settings and pin code use:
Menu>Restore to Default
On the IQ260 you can change the hostname, set a pin code or select a
specic network channel under: Menu>WiFi >Settings
N.B. Only basic ASCII (i.e. basic English) characters are supported when
working wirelessly with host names, user names and passwords.
To Next Page
Loading...
Need help?
General
