4
HD11 XE Getting Started
4535 612 62651
103
Using the System
Assigning Keys to Peripherals
If you have a VCR, a printer, or a serial output cable, you must assign a record key
to each one. The record keys, which appear on the system control panel, are
labeled Rec 1, Rec 2, and Rec 3. You can also assign the Acquire key to a local
printer.
➤ To assign a key to a peripheral or to a serial output cable
1. Press Setup.
2. Click the Peripherals tab.
3. On the Peripherals tab, select from the menu the device that you want asso-
ciated with each Record key.
4. Click Config to configure the device, if required.
5. To use the Acquire key to print, select the printer.
– Click Config to configure USB printer drivers, if required.
– If you are printing multiple images per page, click Auto Print to specify
Batch mode or Send as you go.
6. To print multiple pages per sheet:
–Select the Key to use for multiple images per sheet from the menu.
– Click Layout to specify the number of images per page.
7. Click Apply or Save, and then click Close.
NOTE
Your Philips representative types a value for the Ta p e T i m e setting when install-
ing peripherals. This setting determines the time displayed on the display when a
videotape is inserted into the VCR. You can change this setting when you assign a
Record key to a peripheral.
Connecting and Configuring the Foot Switch
The foot switch lets you control three of the most commonly used functions with
your foot. This keeps your hands free to use the transducer and the other system
controls. You can use the foot switch during 2D and stress imaging. For 2D imag-
ing, you can change the default configuration of the foot pedals, but you cannot
for stress imaging.
To Next Page
Loading...