Using the System
HD11 XE Getting Started
4535 612 62651
4
102
Connecting a VCR
You can connect either an NTSC or a PAL VCR to your ultrasound system. The
system only supports the Mitsubishi HS-MD3000 VCR for controlling the VCR
through the system control panel. If you connect an unsupported VCR, you must
control the VCR features by using the controls on the VCR.
➤ To connect the VCR
1. Turn off the system and unplug the power cord from the power source.
2. Lift the peripheral housing garage up and off of the back of the system cart.
3. Loosen the cart strap and slide the VCR under the strap on top of the cart.
4. Tighten the strap to secure the VCR in place.
5. Connect the cables. For an illustration of the peripheral connections, see
Figure 4-2. For an illustration of the system cart and cables, see Figure 4-3.
a. Connect the audio in and audio out cables to the back of the VCR.
b. Connect the S-Video in and S-Video out cables to the back of the VCR.
c. Connect the power cord to the back of the VCR.
d. If the VCR is supported, connect the 25-pin control cable to the back of
the VCR. This allows you to control the VCR features, using the system
control panel.
NOTE
The VCR must have S-Video in and S-Video out ports to accept S-Video as input.
6. Align the peripheral housing garage with the four pins on the cart and push
the garage into place on the back of the cart.
7. Reconnect the system’s power cord to the power source.
8. Turn the VCR on, and then turn on the system.
To Next Page
Loading...