Philips Respironics SimplyGo Mini User Manual

18
SimplyGo Mini User Manual
To set up the SimplyGo Mini device, follow these steps�
1� Connect a nasal cannula to the patient cannula connector on the
device, as shown� Ensure that the cannula is routed to prevent it from
being pinched or kinked to avoid a disruption of oxygen ow�
Note: Note: A standard single lumen nasal cannula and tubing (not supplied)
should be used to deliver oxygen from the SimplyGo Mini device�
The device works with smooth bore cannula tubing up to 25 ft� (7�6
m); however, use of shorter cannula lengths deliver higher pulse
performance� See Specications section under “Flow Settings and Pulse
Volumes” for additional details. The proper placement and positioning
of the nasal cannula in the nose is critical to the consistent operation of
the SimplyGo Mini�
2� Power on the device as described in
the next section�
3� Position the nasal cannula on your
face, as shown below, and breathe
normally through your nose�

Philips Respironics SimplyGo Mini Specifications

General

Battery Duration (Standard Battery)	Up to 4.5 hours
Battery Life	Up to 4.5 hours with standard battery, up to 9 hours with extended battery
Oxygen Concentration	87% to 96% at all settings
Pulse Dose Settings	1 to 5
Recharge Time (Standard Battery)	Approximately 4 hours
Recharge Time (Extended Battery)	8 hours
Operating Altitude	Up to 10, 000 feet (3048 meters)
Sound Level	43 dBA (at pulse dose setting 2)
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Altitude Range	Up to 10, 000 feet (3048 meters)
Weight	5 lbs (2.3 kg) with standard battery
Humidity Range	15% to 95% non-condensing