Philips Respironics SimplyGo Mini - Operating the SimplyGo Mini Device; Power Options: Battery, AC, and DC Power

15
SimplyGo Mini User Manual
English
Operating the SimplyGo Mini Device
Power Options
Warning: Do not use the device without the battery installed and operating�
• To run the device on battery power, make sure the battery is properly
inserted and suciently charged� (The battery should be fully
charged the rst time you use it�)
• To run the device using AC power, rst make sure you have a
battery installed� Then, follow these steps:
1� Connect the output cable of the AC Power Supply to the
SimplyGo Mini power input connector, aligning the green dots
on the power cord and device as shown below�
2� Connect the AC Power Cord’s connector into the AC power
supply�
3� Connect the AC Power Cord’s plug into an AC outlet installed to
meet national or regional electrical code�
• To run the device using DC power from an automobile or other
motorized vehicle, make sure the battery is installed� Start the vehicle
and connect one end of the DC Power Cord to the device’s power
inlet and the other end into the vehicle’s DC electrical outlet�
SimplyGo Mini Power Cord Connection
When connecting the SimplyGo Mini
device to either an AC or DC power supply:
1� Align the green dot indicators
on the power cord�
2� Insert the cord connection
into the device as shown in
the illustration�
Note: DC power provided by the DC
Power Supply will also charge the battery when the device is turned o
or is running on setting 1, 2, or 3� It may not charge the battery when
the device is running on setting 4 or 5� Charging status can be veried
with the battery icon on the Home Screen�
Green Dots