6. Tap Letter.
7. Tap in the Country field and use the keypad to enter the destination country.
8. Select special services, if required.
9. Tap Apply.
10. Place the envelope on the scale. The weight appears.
11. Place the envelope or envelopes on the feed deck. Depending on the SendPro C model you
have, feed the envelopes manually or tap Start to feed the envelopes.
Note: Your device will upload transactions if you have previously printed any mail. Once the upload
completes, you see the message "Transaction upload status, Upload success" with a check mark.
Tap the check mark.
Advancing the date
Watch this video or follow the instructions below to learn how to advance the date.
Advance the date to print postage up to thirty days before you need to send it.
1. Tap Envelope Printing on the Home screen.
2. Tap the date. The calendar appears.
3. Tap Tomorrow or Another Date, depending on the date you wish to print.
4. When you see the future date highlighted on the calendar, tap Apply.
5. Place the envelope or envelopes on the feed deck. Depending on the SendPro C model you
have, feed the envelopes manually or tap Start to feed the envelopes.
Important: The date on the postage should match the date when your mail goes to the post office.
Your device automatically advances the printed date on the device stamp (as well as its internally held
date) when the device time reaches 5:00 PM. You cannot change this time.
Printing additional postage
If you do not have enough postage on an envelope, you can add more postage directly on a blank area
on your envelope or you can print the additional postage on a tape.
Printing on envelopes
Pitney Bowes Operator Guide April 2022 147
To Next Page
Loading...
