Plum MacBAT 5 - Measurement Counter Setting

E-10
MacBAT 5 – USER GUIDE. Version 1.0
To setup the measurement counter (Vm) value:
• Go to Main menu by pressing Enter
• Navigate to menu Counters and flow → Volume → Current
• Press Enter on parameter Vm to change the value of gas meter
To setup the pulse factor for gas meter:
• Go to Main menu by pressing Enter
• Navigate to menu Measuring inputs → Gas meter → Pulse factor
• Press Enter on parameters related to pulse factors for LF and HF inputs if they are used
At first remember to set proper gas meter inputs variant what is described in paragraph PULSE INPUTS
CONFIGURATION
In case of using Encoder functionality – ConfImp set to SCR or EN, Vm will be adjusted automatically.