E-12
MacBAT 5 – USER GUIDE. Version 1.0
Substitute values for pressure and temperature are the ones taken for PTZ calculation when device works in error conditions, for example
pressure out of range, temperature out of range.
Substitute pressure is important for device in variant Temperature corrector. This settings set the pressure for fixed
value used constantly for calculation.
To setup the substitute pressure value:
• Go to Main menu by pressing Enter
• Navigate to menu Measurement inputs → Pressure 1 → Advanced
• Press Enter on parameter p1subst to perform changes
To setup the substitute temperature value:
• Go to Main menu by pressing Enter
• Navigate to menu Measurement inputs → Temperature → Advanced
• Press Enter on parameter tSubst to perform changes
To Next Page
Loading...