FINAL DRIVE
7.9
16--19 ft.lbs.
NOTE:Thechainmaybeinstalledat thispoint orlater
in the procedure.
3. Install the spacer and sprocket guard (D). Install
the sprocket guard nuts, torque to 25--30 ft.lbs.
(34--41 Nm).
4. Install theO--ring (E), brakedisc (F), and axlenut
(G) onto the axle.
G
F
E
5. Install the retaining ring (H) onto the axle. It
should fully seat into the groove.
6. Turn the axle nut outward with a 1 3/4” Wrench
(PN 2870772)untiltheend of the axlenut (G)just
covers the retaining ring (H). The retaining ring
should still be visible under the axle nut from an
angle. Torque to 8--10 ft.lbs. (11--14 Nm)
H
7. Torque theaxlenutpinch bolt to50in.lbs. (6Nm).
50 in.lbs.
H
8. Reinstall the chain and master link. To verify
proper chain tension, refer to Chapter 2 “DRIVE
CHAIN INSPECTION” for this procedure.
9. Torque the eccentric clamp bolts to 35 ft.lbs. (47
Nm).
35 ft.lb s .
10. Installcaliper,twomountingbolts and lockwashers.
Torque mounting bolts to 18 ft.lbs. (25 Nm).
PartShark.com
877-999-5686
To Next Page
Loading...
