24-3
04
51
Daily Plant Checks
EN
NOTICES
Check frequently the stability of the plant.
The chassis SHOULD NOT bounce during
operation.
DO NOT run the engine below its
recommended working speed when
crushing.
Check regularly that all cooler fans are
running correctly and that dust or dirt has
not built up in the fan and radiator or heat
exchanger element. Overheating can
occur if dust or dirt is allowed to build up.
Clean out if necessary.
Avoid frequent starting and stopping of
the plant unnecessarily, as it will cause
damage to the plant and excessive wear.
5. Make sure all warning and safety signs are
clean and visible, see plant specication and
information for their positions.
6. Ensure that the crusher and the feed hopper are
empty.
SKIN INJECTION
HAZARD
n DANGER
Refer to Safety Notices Section for relevant
warning and procedure
7. Check hydraulic oil level and lter condition
indicators.
8. Visually check the hydraulic system for damage
or leaks.
To Next Page
Loading...