ProSoft PLX32-EIP-MBTCP-UA - 2.7.1 From Address; 2.7.2 To Address; 2.7.3 Register Count

PLX32-EIP-MBTCP-UA ♦ Multi-Protocol Gateway Using ProSoft Configuration Builder
User Manual
ProSoft Technology, Inc. Page 25 of 156
March 8, 2018
4 Click EDIT ROW to edit the parameters for the mapping.
5 To change the value of a parameter, click the parameter and enter a new
value. Click OK when finished.
6 Repeat the above steps to add more memory mappings.
2.7.1 From Address
0 to highest Status Data address
Specifies the beginning internal database register address for the copy operation.
This address can be any valid address in the user data area or the status data
area of the gateway.
2.7.2 To Address
0 to 3999
Specifies the beginning destination register address for the copy operation. This
address must always be within the user data area. Make sure you specify a
destination address that does not overwrite data that is stored in memory by one
of the communication protocols running on the gateway.
2.7.3 Register Count
1 to 100
Specifies the number of registers to copy.