Risk of incorrect measurements due to electromagnetic interference
High frequency radiation or electrostatic discharge in the vicinity of the measuring device
and measuring equipment can lead to faulty measurements.
o
Select a measurement site with low electromagnetic radiation exposure.
Data security
Risk of data loss!
o
Back up the measurement data in the OMNITREND Center PC software after com-
pletion of data acquisition.
o
Back up the data prior to resetting the measuring device to the factory settings.
1.2.2 Intended use
The measuring device may only be used for the measurement of electrical signals in the in-
dustrial area taking into account the technical specification. Sensors and cables may only
be used in the specified area. The currently applicable technical specification can be found
in the Condition Monitoring catalog, which can be downloaded free of charge from the
PRÜFTECHNIK homepage.
Any use beyond that is considered unintended and is not permissible. Faulty or im-
permissible use as well as nonobservance of the information in these instructions shall
void the manufacturer’s liability.
If the measuring device is used in a manner not intended by the manufacturer, device pro-
tection may be impacted.
1.2.3 Conformity
VIBSCANNER 2 complies with the relevant European directives. The complete Declaration
of Conformity can be found at www.pruftechnik.com.
VIBSCANNER 2 13
1 - Introduction
To Next Page
Loading...
Need help?
General
