possible to the transponder (approx. 2-3 cm) to record the measurement location coding
("Non-contact detection or measurement locations (RFID)" on page 67).
Identifying measurement locations using RFID technology (ISO 14443a and ISO 15693).
2.6.3 Sensor for ambient light
This sensor increases ease of operation and reduces power consumption at the same
time by automatically adjusting the display brightness relative to the ambient light. Both
inlet openings are located below the display area and must remain unobstructed if pos-
sible.
The sensor function can be switched on and off in the device settings: [Settings > Display
> Automatic brightness].
Two inlet openings for ambient light sensor.
26 Edition: 11.2017
2 - Description
To Next Page
Loading...
