4. The screen manual IP configuration will show:
- IPv4 Address: Empty by default. Value chosen by Supervisor.
- IPv4 Subnet mask: Empty by default. Value chosen by Supervisor.
- IPv4 Default Gateway IP Address: Empty by default. Value chosen by
Supervisor.
- IPv6 Address: Blank on first use and otherwise displays last-entered address.
- IPv6 Prefix length: Blank on first use and otherwise displays last-entered
address.
Press [OK].
5. Set parameters in the manual DNS configuration screen:
- Preferred DNS IPv4: Empty by default. Value chosen by Supervisor.
- Alternate DNS IPv4: Empty by default. Value chosen by Supervisor.
- Preferred DNS IPv6: Empty by default. Value chosen by Supervisor.
- Alternate DNS IPv6: Empty by default. Value chosen by Supervisor.
Press [OK], the system will reverts to the start screen so that you can apply any
changes.
11
Configuring your Mailing System
341
| Page 341 | Jan-15-2024 09:55 |
To Next Page
Loading...
