R&S FPC Series - Page 311

Remote Control
R&S
®
FPC
308User Manual 1178.4130.02 ─ 07
Usage: Query only
[SENSe:]ADEMod:FM:OFFSet?
This command queries the frequency deviation.
Prerequisites for this command
●
Measure an FM signal (CALCulate<n>:FEED).
Return values:
<Frequency> <numeric value>
Default unit: Hz
Example: //Query frequency deviation
CALC:FEED 'XTIM:FMS'
ADEM:FM:OFFS?
Usage: Query only
TRACe[:DATA]?
This command queries the trace data (measurement results in graphical result dis-
plays).
Prerequisites for this command
●
Select graphical result display (CALCulate<n>:FEED).
Return values:
<Results> Returns one value for each measurement point.
The type of value depends on the measurement (Hz for FM,
PCT for AM).
Example: //Query FM results
CALC:FEED 'XTIMe:FM'
TRAC?
Usage: Query only
19.14.2 Frequency
Commands to configure the frequency described elsewhere.
●
Center frequency:
[SENSe:]FREQuency:CENTer
●
Frequency stepsize:
[SENSe:]FREQuency:CENTer:STEP
Remote Commands of the Analog Demodulation