R&S FPC Series - Page 356

Remote Control
R&S
®
FPC
353User Manual 1178.4130.02 ─ 07
Parameters:
<SumBit> <numeric value> (integer)
Range: 0 to 65535
STATus:OPERation:PTRansition <SumBit>
This command controls the Positive TRansition part of the OPERation register.
Setting a bit causes a 0 to 1 transition in the corresponding bit of the associated regis-
ter. The transition also writes a 1 into the associated bit of the corresponding EVENt
register.
Parameters:
<SumBit> <numeric value> (integer)
Range: 0 to 65535
STATus:QUEStionable:FREQuency[:EVENt]?
STATus:QUEStionable:LIMit[:EVENt]?
STATus:QUEStionable:POWer[:EVENt]?
STATus:QUEStionable[:EVENt]?
This command reads out the EVENt section of the QUEStionable register.
The command at the same time deletes the contents of the EVENt section.
Return values:
<Condition>
Usage: Query only
STATus:QUEStionable:FREQuency:CONDition?
STATus:QUEStionable:LIMit:CONDition?
STATus:QUEStionable:POWer:CONDition?
STATus:QUEStionable:CONDition?
This command reads out the CONDition section of the QUEStionable register.
The command does not delete the contents of the EVENt section.
Return values:
<Condition>
Usage: Query only
STATus:QUEStionable:FREQuency:ENABle <SumBit>
STATus:QUEStionable:LIMit:ENABle <SumBit>
STATus:QUEStionable:POWer:ENABle <SumBit>
STATus:QUEStionable:ENABle <SumBit>
This command controls the ENABle part of the QUEStionable register.
Status Reporting System