R&S FPC Series - Page 357

Remote Control
R&S
®
FPC
354User Manual 1178.4130.02 ─ 07
The ENABle part allows true conditions in the EVENt part of the status register to be
reported in the summary bit. If a bit is 1 in the enable register and its associated event
bit transitions to true, a positive transition will occur in the summary bit reported to the
next higher level.
Parameters:
<SumBit> <numeric value> (integer)
Range: 0 to 65535
STATus:QUEStionable:FREQuency:NTRansition <SumBit>
STATus:QUEStionable:LIMit:NTRansition <SumBit>
STATus:QUEStionable:POWer:NTRansition <SumBit>
STATus:QUEStionable:NTRansition <SumBit>
This command controls the Negative TRansition part of the QUEStionable register.
Setting a bit causes a 1 to 0 transition in the corresponding bit of the associated regis-
ter. The transition also writes a 1 into the associated bit of the corresponding EVENt
register.
Parameters:
<SumBit> <numeric value> (integer)
Range: 0 to 65535
STATus:QUEStionable:FREQuency:PTRansition <SumBit>
STATus:QUEStionable:LIMit:PTRansition <SumBit>
STATus:QUEStionable:POWer:PTRansition <SumBit>
STATus:QUEStionable:PTRansition <SumBit>
This command control the Positive TRansition part of the QUEStionable register.
Setting a bit causes a 0 to 1 transition in the corresponding bit of the associated regis-
ter. The transition also writes a 1 into the associated bit of the corresponding EVENt
register.
Parameters:
<SumBit> <numeric value> (integer)
Range: 0 to 65535
Status Reporting System