Recognition Systems HandKey II - Set Beeper

HandKey II Installation and Operation Manual
Revision 2.0 Page 115
Set Beeper
Set the Beeper Options to whether or not the Hand Reader’s beeper should sound an
audible response to key strokes and events.
1. When you enter the Set Beeper command the display appears as follows.
2. Press to exit the command menu.
– or –
3. Press to keep the current Beeper setting and return to the Set Language
command at the beginning of this command menu.
– or –
4. Press to Set the Beeper. The beeper option appears on the display.
5. Press to keep the Beeper on.
– or –
6. Press to turn the Beeper off.
7. The display returns to the start of the Set Beeper command.
8. Press to return to the Set Language command at the beginning of this
command menu.
– or –
9. Press to exit command mode.
SET BEEPER
*NO YES#
5
*
#
TURN BEEPER OFF
*NO YES#
*
#
SET BEEPER
*NO YES#
*
5