Recognition Systems HandKey II - Set ID Length

HandKey II Installation and Operation Manual
Page 92 Revision 2.0
Set ID Length
Set the ID Length to the number of digits in the longest ID number. This command is
unnecessary (and should be left at its default value) if ID entry is made from a card
reader. The ID Length should not be set if a Duress Code is being assigned (see
page 113). The default value for ID Length is 10.
NOTE: Users assigned ID numbers shorter than the number of digits in the longest ID
number must press following their ID entry to indicate the complete entry has
been made.
The following instructions demonstrate how to change the Hand Reader’s ID length
from the default of 10 digits to 4 digits.
1. When you enter the Set ID Length command the display appears as follows.
2. Press to exit the command menu.
– or –
3. Press to keep the current ID Length and skip to the Set Output Mode
command.
– or –
4. Press to Set the ID Length. The current ID Length appears on the display.
5. Press to set the ID length to 4. The display returns to the start of the Set ID
Length command.
#
SET ID LENGTH
*NO YES#
5
*
#
LENGTH IS 10
NEW?
4 #
SET ID LENGTH
*NO YES#