HandKey II Installation and Operation Manual
Revision 2.0 Page 77
Management Menu
The Management menu has three commands for managing user data in a Hand Reader
and in a Hand Reader network.
List Users – Display or print a list of all the users enrolled in a Hand Reader.
Data From Network – Upload data from the network to the master Hand Reader.
Data To Network – Download data from a master Hand Reader to the network.
The following sections describe all the Management menu options. All commands are
described in the order they are accessed. Locate the command you need to perform and
step through all previous commands until you reach the desired command.
List Users
The List Users command displays or prints a list of all the users enrolled in a Hand
Reader. The list is shown, one user at a time, on the Hand Reader’s display, or it is
printed by a serial printer attached to the Hand Reader being polled or to a printer
attached to the Master Hand Reader in a Hand Reader network. Before displaying the
user list, the amount of memory available for enrolling more users is displayed.
The following instructions demonstrate how to generate a Hand Reader’s user list.
1. Enter the Management command menu per the instructions in the Enter a
Command Menu section earlier in this Manual. The default password for the
Management menu is “3.” When you enter the Management command menu the
List Users command appears on the display.
2. Press to exit the command menu.
– or –
3. Press to skip to the Data From Network command (if the Hand Reader is the
master Hand Reader in a network).
– or –
4. Press to List Users. The Hand Reader’s display appears as follows.
LIST USERS
*NO YES#
5
*
#
0 - DISPLAY
1 - PRINT
To Next Page
Loading...
