Recognition Systems HandKey II - Set User Data; Set User Authority Level

HandKey II Installation and Operation Manual
Page 44 Revision 2.0
Set User Data
The Set User Data command allows you to set the User Authority level, the User
Reject Level, and the User Time Zone.
• The Authority Level controls which command menus a user is allowed to access;
the higher the authority level, the greater the number of menus the user may
access.
• The User Reject level allows you to set the number of failed hand read attempts for
a user before rejecting further attempts by that user.
• The User Time Zone allows you to assign a time zone to a user, restricting the
time-of-day that a user may be granted access.
Set User Authority Level
In the following example a user with ID # 321 is assigned Authority Level 4.
1. Enter the Security command menu per the instructions in the Enter a Command
Menu section earlier in this Manual. The default password for the Security menu is
“5.” When you enter the Security command menu the display appears as follows.
2. Press to exit the command menu.
– or –
3. Press to skip to the Set TZ Table command.
– or –
4. Press to Set User Data. The display appears as follows.
5. Press to skip to the Set User Reject command.
– or –
6. Press to Set User Authority. The display appears as follows.
SET USER DATA
*NO YES#
5
*
#
SET USER AUTH?
*NO YES#
*
#
ID# ?
#: