Recognition Systems HandKey II - Set User Time Zone

HandKey II Installation and Operation Manual
Page 48 Revision 2.0
Set User Time Zone
In the following example the time zone for the user with ID # 123 is set to 12.
1. When you enter the Set User Time Zone command the display appears as follows.
2. Press to exit the command menu.
– or –
3. Press to return to the Set User Authority Level command at the beginning of
this command menu.
– or –
4. Press to Set User Time Zone. The display appears as follows.
5. Enter the user’s ID number. Press . The display shows the current
time zone assigned to this user.
6. Enter the new time zone for this user. Press . The display appears as
follows.
SET USER TZ?
*NO YES#
5
*
#
ID#?
#:
1
2
3 #
NEW TZ (0)?
1 2 #
ID#?
#: