HandKey II Installation and Operation Manual
Page 94 Revision 2.0
Set Output Mode
Lock and Auxiliary Output and Card Reader Output are the two output mode choices.
The selected mode is applied to Output 0. Lock and Auxiliary Output mode is the
default setting.
1. When you enter the Set Output Mode command the display appears as follows.
2. Press to exit the command menu.
– or –
3. Press to keep the current Output Mode and skip to the Set Facility command.
– or –
4. Press to Set the Output Mode. The current Output Mode appears on the
display.
5. Press to keep the current Output Mode and skip to the next command.
– or –
6. Press to change to Card Reader Output Mode. The new Output Mode appears
on the display.
7. Press to step to the Set Facility command.
– or –
8. Press to exit command mode.
SET OUTPUT MODE
*NO YES#
5
*
#
FOR LOCK & AUX
*NO YES#
#
*
FOR CARD RDR OUT
*NO YES#
#
5
To Next Page
Loading...
