Recognition Systems HandKey II - Set User Reject Level

HandKey II Installation and Operation Manual
Page 46 Revision 2.0
Set User Reject Level
In the following example the reject level for the user with ID # 123 is set to 5.
1. When you enter the Set User Reject Level command the display appears as
follows.
2. Press to exit the command menu.
– or –
3. Press to skip to the Set User Time Zone command.
– or –
4. Press to Set User Reject. The display appears as follows.
5. Enter the user’s ID number. Press . The display shows the current
reject level for this user.
6. Enter the new reject level for this user. Press . The display appears as
follows.
SET USER REJECT?
*NO YES#
5
*
#
ID#?
#:
1
2
3 #
REJ. AT (0)?
5 #
ID#?
#: