Recognition Systems HandKey II - Exiting Status Display

HandKey II Installation and Operation Manual
Page 122 Revision 2.0
Exiting Status Display
1. When you enter the Status Display command the following appears on the Hand
Reader’s display.
2. Press to exit the command menu.
– or –
3. Press to skip to the Network Status command (if the Hand Reader is the
Master Hand Reader in a network).
– or –
4. Press to Display Hand Reader Status. The Hand Reader’s display appears as
follows.
5. The Hand Reader’s display shows the current OFF/ON value of the status display
command.
6. If the current value is OFF, skip to Step 9.
7. If the current value is ON press to turn the status display command OFF. The
Hand Reader’s display appears as follows.
8. Press to re-enter the status display command.
9. The Hand Reader’s display appears as follows.
STATUS DISPLAY
*NO YES#
5
*
#
STATUS DISPLAY
ON *NO / #Y ?:
#
STATUS DISPLAY
*NO YES#
#
STATUS DISPLAY
OFF *NO / #Y ?: