Recognition Systems HandKey II - Set Address

HandKey II Installation and Operation Manual
Revision 2.0 Page 91
Set Address
You must set the Hand Reader address if the Hand Reader is connected to a master/
remote Hand Reader network or to a Hand Reader network connected to a host PC
(stand-alone Hand Readers do not require an address). Addresses 0 to 254 are
available – address 255 is reserved for the master Hand Reader in a network. Each
Hand Reader on a network must have a unique address. The default address for all
Hand Readers is 0.
The following instructions demonstrate how to change the Hand Reader’s address
from the default address of 0 to address 2.
1. When you enter the Set Address command the display appears as follows.
2. Press to exit the command menu.
– or –
3. Press to keep the current address and skip to the Set ID Length command.
– or –
4. Press to Set the Reader Address. The current address appears on the display.
5. Press to set the Hand Reader address to 2. The display returns to the start
of the Set Address command.
6. Press to step to the Set ID Length command.
– or –
7. Press to exit command mode.
SET ADDRESS
*NO YES#
5
*
#
RDR ADD IS 0
NEW?
2 #
SET ADDRESS
*NO YES#
*
5