HandKey II Installation and Operation Manual
Page 74 Revision 2.0
Remove User
Use the Remove User command to remove a user that has been entered incorrectly or
needs to be removed from the Hand Reader system.
Once a user has been removed from the Hand Reader, that user no longer has access
through the door controlled by that Hand Reader. To be granted access again, that
user must be re-enrolled.
The following instructions demonstrate how to remove a user with ID number 321.
1. When you enter the Remove User command the Hand Reader’s display appears as
follows.
2. Press to exit the command menu.
– or –
3. Press to return to the Add User command at the beginning of this command
menu.
– or –
4. Press to enter the Remove ID # command. The Remove ID # request appears
on the display.
5. Enter the user’s ID. For this example, press . The Remove ID #
request appears on the display again.
6. The User Removed message appears briefly on the display.
7. After a short delay the Remove ID # request reappears on the display.
NOTE
REMOVE USER
*NO YES#
5
*
#
REMOVE ID #
:
3 2 1 #
USER REMOVED
To Next Page
Loading...
