Recognition Systems HandKey II - Set Language

HandKey II Installation and Operation Manual
Revision 2.0 Page 87
Set Language
The default language is English. The following languages are available.
French Japanese
German Portuguese
Indonesian Russian
Italian Spanish
1. Enter the Setup command menu per the instructions in the Enter a Command
Menu section earlier in this Manual. The default password for the Setup menu is
“2.” When you enter the Setup command menu the Set Language command
appears on the display.
2. Press to exit the command menu.
– or –
3. Press to keep the current language and skip to the Set Date Format command.
– or –
4. Press to Set a Language. The current language appears on the display.
5. Press to step through the list of available languages until the desired language
appears on the display, then press to select the language. The display returns to
the start of the Set Language command with the text displayed in the selected
language.
6. Press to step to the Set Date Format command.
– or –
7. Press to exit command mode.
SET LANGUAGE
*NO YES#
5
*
#
(LANGUAGE NAME)
*NO YES#
*
#
(SET LANGUAGE)
*NO YES#
*
5