Recognition Systems HandKey II - Core Reader Operations and Programming

HandKey II Installation and Operation Manual
Revision 2.0 Page 37
Programming the Hand Reader
The Hand Reader is programmed via a series of command menus. A summary of the
menus and commands is given in Table 6.
* These menu options only appear in Hand Readers configured as “Master.”
Table 6: Basic Command Mode Structure
Security Menu Enrollment
Menu
Management
Menu
Setup Menu Service Menu
Set User Data Add User List Users Set Language Calibrate
Set TZ Table Add/Remove
User
Data From
Network*
Set Date Format Status Display
Reject
Threshold
Data to
Network*
Set Time
and Date
Network Status*
Set Passwords Set Address
Clear Memory Set ID Length
Special Enroll Set Output
Mode
Set Facility
Lock/Shunt
Time
Aux Out Control
Set Reader
Mode
Set Serial
Set Duress Code
Print Options
Set Beeper