Recognition Systems HandKey II - Clear Time Zone

HandKey II Installation and Operation Manual
Revision 2.0 Page 55
Clear Time Zone
The following section provides an example of clearing time zone 2.
1. When you enter the Clear Time Zone command the display appears as follows.
2. Press to exit to the Set TZ Table command.
– or –
3. Press to skip to the Edit Holidays command.
– or –
4. Press to clear a time zone. The display appears as follows.
5. Press to skip to the Edit Holidays command without clearing a time zone.
– or –
6. To ensure you want to clear a time zone, a prefix must be entered before the time
zone is entered. To clear a time zone, enter the prefix followed by the time zone.
To clear time zone 2, press . The time zone is cleared and the
display steps to the Edit Holidays command.
CLEAR TZ’s
*NO YES#
5
*
#
TO CLEAR ENTER
123# ELSE #?:
#
1 2 3 # 2