HandKey II Installation and Operation Manual
Revision 2.0 Page 59
Clear Holidays
When you clear holidays, you clear all holidays in a month. That means that if any
holidays should be in that month, they must be reentered (see the Edit Holidays
command on page 56).
1. When you enter the Clear Holidays command the display appears as follows.
2. Press to exit to the Set TZ Table command.
– or –
3. Press to skip to the Set Unlock Time Zone command.
– or –
4. Press to clear holidays. The display appears as follows.
5. Press to skip to the Set Unlock Time Zone command without clearing a
holiday.
– or –
6. To ensure you want to clear a holiday, a prefix must be entered before the holiday
month is entered. To clear a holiday month, enter the prefix followed by the
number corresponding to the month. To clear December holidays, press
. All the holidays in the month are cleared and the display steps to
the Set Unlock Time Zone command.
CLEAR HOLIDAYS
*NO YES#
5
*
#
TO CLEAR ENTER
123# ELSE #?:
#
1 2
3 # 1 2
To Next Page
Loading...
