HandKey II Installation and Operation Manual
Page 78 Revision 2.0
5. Press to list the users on the Hand Reader’s display.
6. Press to list the users on the serial printer.
7. The memory available for enrolling more users is displayed on the Hand Reader’s
display or is printed at the serial printer.
8. Press to step to the first user enrolled in the Hand Reader. The first user’s data
is shown on the display.
9. Press to step to the next user in the list.
– or –
10. Press to stop displaying the user list. The following appears on the display.
11. Press to exit the User List command. The following appears on the display.
12. Press to exit command mode.
– or –
13. Press to step to the Data From Network command.
– or –
14. Press to return to the List Users command. Repeat this procedure beginning at
Step 4.
0
1
USER SPACE XXX
#
(ID) (REJ) (AUTH)
(TZ) MORE (#Y / *N)
#
*
DONE. PRESS KEY
*
LIST USERS
*NO YES#
5
*
#
To Next Page
Loading...
