HandKey II Installation and Operation Manual
Page 42 Revision 2.0
4. Enter the password for the menu you wish to enter. The default passwords are as
follows.
Press for the Service Menu.
Press for the Setup Menu.
Press for the Management Menu.
Press for the Enrollment Menu.
Press for the Security Menu.
5. Press .
6. If you are authorized to use this command the first command option in the selected
menu appears.
7. If you are not authorized to enter this command the display appears as follows.
To access all five menus you must be the first person enrolled in a new system
installation or you must have the highest authority level and the correct passwords for
all five menus. If you are blocked from a menu to which you should have access, verify
your access/password rights with management personnel. If authority levels or
passwords have been incorrectly changed and you must have access to all menus, it is
possible to reset the Hand Reader’s memory. Resetting memory allows access to all
five menus by the first person enrolled (as if it is a new system installation), but this
means that any user information programmed into the Hand Reader must be re-
entered (manually or by using HandNet software to restore the user information). Be
sure you need to reset memory before performing this function. To reset memory, refer
to the Erasing Hand Reader Memory
section on page 35.
1
2
3
4
5
ENTER
READY
*:
NOTE
To Next Page
Loading...
