Recognition Systems HandKey II - Page 97

HandKey II Installation and Operation Manual
Revision 2.0 Page 97
6. Press to set the Shunt time to 12 seconds. The current Auxiliary
Keypad value appears on the display.
7. Press to enable unlocking when the user’s ID number is entered at the
Auxiliary Keypad. The current Auxiliary Keypad Use Time Zone value appears on
the display.
8. Press to keep the current Auxiliary Keypad value.
– or –
9. Press if the time zone assigned to the user should be applied when the user’s
ID number is entered at the Auxiliary Keypad. This means that to be granted
access, the time zone assigned to the user must be valid.
– or –
10. Press if the time zone assigned to the user should not be applied when the
user’s ID number is entered at the Auxiliary Keypad. This means that the user will
be granted access regardless of the time zone assigned to the user.
11. The display returns to the start of the Set Lock and Shunt command.
12. Press to step to the Aux Out Control command.
– or –
13. Press to exit command mode.
1 2 #
UNLK ON AUX KPD
(Y#) ?:
#
AUX KPD USE TZ
(Y#) ?:
*
#
*
LOCK/SHUNT TIME
*NO YES#
*
5