26 January, 2001 1000-SHEET FINISHER INSTALLATION
1-35
Installation
9. Secure the finisher [A] (! x1).
10. Adjust the securing knobs [B] under the front and rear stands until the finisher
is perpendicular to the floor.
11. Install the shift tray [C] (snap ring x1).
NOTE: Make sure that the three pegs [D] fit into the slots [E] properly.
12. Connect the finisher cable [F] to the main machine.
13. Turn on the main power switch and check the finisher operation.
A681I706.WMF
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
