2. By-pass tray (See ‘Covers and Common Units – By-pass Tray Unit’)
3. LCT (if installed)
4. Lower right cover [A] ( x5)
5. Vertical transport cover [B]
• Push the cover completely to the left and then press in on the right tab to release the peg from
the hole.
Relay/Upper Paper Feed and Lower Paper Feed Clutches
1. Rear lower cover (See ‘Covers and Common Units – Rear Covers’)
2. Remove the IOB. (See ‘Printed Circuit Boards – IOB’)
3. First paper feed clutch bracket [A] ( x2, bushing x1)
4. Second paper feed clutch bracket [B] ( x2, bushing x1)
5. Drive bracket [C] ( x1, spring x1, bearing x1)
Paper Feed
99
To Next Page
Loading...
