Punch Unit (B377)
Accessory Check: Punch Unit
Check the quantity and condition of the accessories in the box against the following list:
No. Description Q’ty
1. Punch unit 1
2. Sensor arm 1
3. Hopper 1
4. Step screw 1
5. Spring 1
6. Spacer (2 mm) 1
7. Spacer (1 mm) 2
8. Tapping screw 1
9. Tapping screw 2
Installation Procedure: Punch Unit
• Switch off the main machine and unplug its power cord. If the Two-Tray Finisher is installed, disconnect
it and pull it away from the machine.
1. Unpack the punch unit and remove all tapes and shipping retainers.
Punch Unit (B377)
39
To Next Page
Loading...
