• The SD card is the only evidence that the customer is licensed to use the application program. The
service technician may occasionally need to check the SD card and its data to solve problems. SD
cards must be stored in a safe location at the work site.A licensing agreement prohibits copying of
the PostScript SD card. However, you can copy an application from another SD card to the PS SD
card. (This restriction may apply to other SD cards as well.)
• If an SD card was used to combine applications on that card, that SD card cannot be used for any
other purpose.
Merging Applications
Do this procedure to put more than one application on one SD card.
• During this procedure, make sure that you put the source SD card and the target SD card in the correct
slots.
1. Turn off the machine.
2. Remove the SD card slot cover [1] ( x2).
3. Put the Source (DOS) SD card [2] in C3. This card contains the application that you want to
copy.
4. Put the Target SD card in C1 [3]. The application on the card in C3 will be copied to this card.
5. Turn the machine on.
1. Installation
50
To Next Page
Loading...
