• You can only install one of these network interfaces: IEEE 802.11b (Wireless LAN), IEEE1284 (Cen-
tronics), or Gigabit Ethernet Board.
1. Remove the cover [1] of board Slot 1 or 2 ( x1)
2. Install the interface board [2] ( x2 knob screws)
• Use a screwdriver to tighten the knob-screws. Do not tighten manually because this can discon-
nect the board.
3. Reattach the application cover ( x1)
IEEE 802.11b Interface Kit (G813)
- Accessories -
Check the accessories and their quantities against the following list:
No. Description Q'ty
1. IEEE 802.11b Board 1
2. PCI Card 1
Controller Options
55
To Next Page
Loading...
