- Procedure -
• Turn off the power switch and disconnect the power supply cord.
• You can only install one of these network interfaces: IEEE 802.11b (Wireless LAN), IEEE1284 (Cen-
tronics), or Gigabit Ethernet Board.
1. Remove the cover [1] of board Slot 1 or 2 ( x1)
2. Attach the interface board [2] to the controller board ( x1 knob screw).
• Use a screwdriver to tighten the knob-screws. Do not tighten manually, because this can dis-
connect the board.
3. With the printed side facing the front of the machine, insert the interface card [3] board.
4. Attach the antenna cap [4].
- SP Mode Settings for IEEE 802.11b Wireless LAN -
The following SP commands and UP modes can be set for IEEE 802.11b
SP No. Name Function
5840 006 Channel MAX Sets the maximum range of the channel settings for the country.
1. Installation
56
To Next Page
Loading...
